The problems of piston skirt microgeometry in combustion engines

Scientific Conference on Automotive Vehicles and Combustion Engines 2016

Iskra, A.^1 ; Babiak, M.^1 ; Wróblewski, E.^1

Faculty of Machines and Transport, Poznan University of Technology, Poland^1

关键词: Bearing surfaces;    Combustion engines;    Friction loss;    Graphite layers;    Micro geometry;    Piston assembly;    Piston skirts;    Tribological properties;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/148/1/012068/pdf
DOI  :  10.1088/1757-899X/148/1/012068

来源: IOP

【 摘 要 】

Geometry of the slot between piston bearing surface and cylinder bore affects the friction losses of the IC engine to the far extent. It appears that these losses depend more on the area covered with oil than the thickness of oil layer separating collaborating parts. Barrel-shaped or stepwise piston bearing surface is the way to reduce the oil covered area. Turns out that the referred to friction losses contributes more to area covered by the oil film than the film thickness of the separation elements cooperating. The method to reduce the area covered by the oil film is a modification of the bearing surface of the piston by adjusting the profile. This paper presents the results of simulation leading to the reduction in friction losses and abrasive wear of piston bearing surface and cylinder bore. Covering the piston bearing surface with a thin layer of graphite one can get an extremely advantageous tribological properties of the piston assembly which means the expected parameters of oil film and in a case of film rupture-an ignorable abrasive wear of the graphite layer and/or cylinder bore.