Specifics of Pulsed Arc Welding Power Supply Performance Based On A Transistor Switch

7th International Scientific Practical Conference "Innovative Technologies in Engineering"

Krampit, N.Yu.^1 ; Kust, T.S.^1 ; Krampit, M.A.^1

Yurga Institute of Technology, TPU Affiliate, Kemerovo Region, Yurga, Russia^1

关键词: Control device;    Control strategies;    Drop transfer;    Electronic component;    High frequency HF;    MOSFET transistors;    Pulsed arc welding;    Transistor switch;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/142/1/012013/pdf
DOI  :  10.1088/1757-899X/142/1/012013

来源: IOP

【 摘 要 】

Specifics of designing a pulsed arc welding power supply device are presented in the paper. Electronic components for managing large current was analyzed. Strengths and shortcomings of power supply circuits based on thyristor, bipolar transistor and MOSFET are outlined. As a base unit for pulsed arc welding was chosen MOSFET transistor, which is easy to manage. Measures to protect a transistor are given. As for the transistor control device is a microcontroller Arduino which has a low cost and adequate performance of the work. Bead transfer principle is to change the voltage on the arc in the formation of beads on the wire end. Microcontroller controls transistor when the arc voltage reaches the threshold voltage. Thus there is a separation and transfer of beads without splashing. Control strategies tested on a real device and presented. The error in the operation of the device is less than 25 us, it can be used controlling drop transfer at high frequencies (up to 1300 Hz).