Ratcheting fatigue behaviour of Al-7075 T6 alloy: Influence of stress parameters

5th National Conference on Processing and Characterization of Materials

Amarnath, Lala^1 ; Bhattacharjee, Antara^1 ; Dutta, K.^1

Department of Metallurgical and Materials Engineering, National Institute of Technology, Rourkela

769008, India^1

关键词: 7075-T6 aluminium alloys;    Aluminium-based alloy;    Constant mean stress;    Cyclic loading experiment;    Strain accumulations;    Structural applications;    Thermal and electrical conductivity;    Universal testing machines;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/115/1/012018/pdf
DOI  :  10.1088/1757-899X/115/1/012018

来源: IOP

【 摘 要 】

The use of aluminium and aluminium based alloys are increasing rapidly on account of its high formability, good thermal and electrical conductivity, high strength and lightness. Aluminium alloys are extensively used in aerospace, automobile, marine and space research industries and are also put into structural applications where chances of fatigue damage cannot be ruled out. In the current work, it is intended to study the ratcheting fatigue behavior of 7075-T6 aluminium alloy at room temperature. This Al alloy is potentially used in aviation, marine and automotive components as well as in bicycle parts, rock mounting equipment and parts of ammunition where there is every chance of failure of the parts due to deformation caused by ratcheting. Ratcheting is the process of accruement of plastic stain produced when a component is subjected to asymmetric cyclic loading under the influence of low cycle fatigue. To accomplish the requirements of the projected research, stress-controlled cyclic loading experiments were done using a ±250 kN servo-hydraulic universal testing machine (Instron: 8800R). The effect of stress parameters such as mean stress and stress amplitude were investigated on the ratcheting behavior of the selected aluminium alloy. It was observed that, ratcheting strain increased with increase in the value of stress amplitude at any constant mean stress while a saturation in strain accumulation attained in the investigated material after around 10-20 cycles, under all test conditions. The analyses of hysteresis loop generated during cyclic loading indicate that the material exhibits cyclic hardening in the initial fifty cycles which gets softened in further loading up to about 70-80 cycles and finally attains a steady state. The increase in the ratcheting strain value with stress parameters happens owing to increased deformation domain during cycling. The cyclic hardening accompanied by softening is correlated with characteristic precipitation features of the investigated Al 7075 alloy.