Influence of RCS on Al-3Mg and Al-3Mg-0.25Sc alloys

2nd International Manufacturing Engineering Conference; 3rd Asia-Pacific Conference on Manufacturing Systems

Bhovi, Prabhakar M.^1 ; Venkateswarlu, K.^2

B.V.B. College of Engineering and Technology, Hubli

580031, India^1

CSIR-National Aerospace Laboratories, Bangalore

560017, India^2

关键词: Al-Mg-Sc alloy;    Average grain size;    Grain formation;    High angle grain boundaries;    Maximum strength;    Repetitive corrugation;    Strength;    Strength property;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/114/1/012100/pdf
DOI  :  10.1088/1757-899X/114/1/012100

来源: IOP

【 摘 要 】

An influence of repetitive corrugation and straightening (RCS) was studied on Al-3Mg and Al-3Mg-0.25Sc alloys up to eight passes. Each pass consist of a corrugation and followed by straightening. This has resulted in introducing large plastic strain in sample, and thus led to formation of sub-micron grain sizes with high angle grain boundaries. These sub grain formation was eventually resulted in improved mechanical properties. The average grain size of Al-3Mg-0.25Sc alloy after 8 passes yielded to ∼0.6pm. Microhardness, strength properties were evaluated and it suggests that RCS was responsible for high hardness values as compared to the as cast samples. The microhardness values after RCS were 105 HV and 130 HV for Al-3Mg and Al-3Mg-0.25Sc alloys, respectively. Similarly, ∼ 40% improvement in tensile strength from 240 MPa to 370 MPa was observed for Al- 3Mg-0.25Sc alloy after RCS process.Al-3Mg and Al-3Mg-0.25Scalloys exhibited maximum strength of 220 MPa and 370 MPa, respectively. It is concluded that RCS process has a strong influence on Al- 3Mg and Al-3Mg-0.25Sc alloys for obtaining improved mechanical properties and grain refinement. In addition to RCS process and presence of AESc precipitates in Al-3Mg-0.25Sc alloy had a significant role in grain refinement and improved mechanical properties as compared to Al-3Mg alloy.