Defining the parameters of a power transmission line equivalent circuit on the basis of phasor measurements

2nd International Conference on Measurement Instrumentation and Electronics

物理学;无线电电子学

Kovalenko, P.Y.^1 ; Berdin, A.S.^1

Automated Electrical Systems Department, Ural Federal University Named after the First President of Russia B.N. Yeltsin, 19 Mira st., Yekaterinburg, Russia^1

关键词: Actual measurements;    Computational model;    Currents and voltages;    Equivalent circuit parameter;    Power system components;    Power system controls;    State measurements;    Steady-state computations;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/870/1/012012/pdf
DOI  :  10.1088/1742-6596/870/1/012012

来源: IOP

【 摘 要 】

Power system control is based on employing its computational model, the backbone of which is an equivalent circuit. The equivalent circuit is involved in solving the problems of steady-state computation and analysis, state estimation, transient analysis etc. Its elements parameters are generally defined by the corresponding equipment reference data or datasheets. Although considered to be constant, these parameters depend upon the element actual load, weather conditions and other factors. Consequently, the results of the outlined problems may be subject to significant bias due to the difference between the reference and the actual elements parameters. Hence the task of identifying the actual equivalent circuit parameters is of paramount importance. In terms of power system control the actual measurements are to be used in order to provide the relevant information on the considered power system component state. As for the transmission lines, the state measurements must include the currents and voltages at both ends of the line regarding the Π-shaped equivalent circuit. That said, at present time the equivalent circuit parameters might be defined involving modern systems of phasor measurements (WAMS) on a real-time basis. The method of defining the equivalent circuit parameters based on phasor measurements along with general relations between power system state parameters is proposed. It should be noted as well that while dealing with the actual WAMS data obtained from power system the measurement errors influence the results quite substantially.