Erosion resistance comparison of alternative surface treatments

6th International Conference on Fracture Fatigue and Wear

esánek, Z.^1 ; Schubert, J.^1 ; Houdková, Š.^1

Výzkumný A Zkuební Ústav Plze, Pilsen, Czech Republic^1

关键词: Coating material;    Erosion resistance;    Functional surfaces;    High-alloyed steels;    Material erosion;    Particle separation;    Surface protection;    Thermal spraying technology;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/843/1/012074/pdf
DOI  :  10.1088/1742-6596/843/1/012074

来源: IOP

【 摘 要 】

Erosion is a process characterized by the particle separation and the damage of component functional surfaces. Thermal spraying technology HP/HVOF (High Pressure / High Velocity Oxygen Fuel) is commonly used for protection of component surfaces against erosive wear. Alloy as well as cermet based coatings meet the requirements for high erosion resistance. Wear resistance is in many cases the determining property of required component functioning. The application suitability of coating materials is particularly influenced by different hardness. This paper therefore presents an erosion resistance comparison of alloy and cermet based coatings. The coatings were applied on steel substrates and were subjected to the erosive test using the device for evaluation of material erosion resistance working on the principle of centrifugal erodent flow. Abrasive sand Al2O3with grain size 212-250 μm was selected as an erosive material. For this purpose, the specimens were prepared by thermal spraying technology HP/HVOF using commercially available powders Stellite 6, NiCrBSi, Cr3C2-25%NiCr, Cr3C2-25%CoNiCrAlY, Hastelloy C-276 and experimental coating TiMoCN-29% Ni. Erosion resistance of evaluated coatings was compared with erosive resistance of 1.4923 high alloyed steel without nitridation and in nitrided state and further with surface treatment using technology PVD. According to the evaluation, the resulting erosive resistance depends not only on the selected erodent and surface protection, but also on the erodent impact angle.