Improvement of torsional fatigue limit and rendering surface defect harmless by shot peening for spring steel

12th International Conference on Damage Assessment of Structures

Takahashi, K.^1 ; Nakagawa, M.^1 ; Koike, H.^1 ; Okada, H.^2

Yokohama National University, 79-5 Tokiwadai, Hodogaya-ku, Yokohama

240-8501, Japan^1

NHK Spring Co. Ltd., 3-10 Fukuura, Kanazawa-ku, Yokohama

236-0004, Japan^2

关键词: Compressive residual stress;    Fatigue Limit;    Practical use;    Smooth specimens;    Spring steel;    Stress ratio;    Torsional fatigue;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/842/1/012066/pdf
DOI  :  10.1088/1742-6596/842/1/012066

来源: IOP

【 摘 要 】

The effects of shot peening (SP) on the torsional fatigue limit of spring steel (SUP7) were investigated for specimens with Vickers hardness values of 460, 540, and 670 HV containing a semicircular surface slit. SP was conducted on smooth specimens and specimens containing a semicircular surface slit with a depth of 0.15 or 0.3 mm. Compressive residual stress was introduced into the specimens by SP. Torsional fatigue tests were carried out under a stress ratio of R = -1. The torsional fatigue limits of the shot peened specimens with Vickers hardness values of 460, 540, and 670 HV increased by 8%-67%, 33%-143%, and 36%-127%, respectively, in comparison with the non-shot peened specimens. The maximum depth of the slit that could be rendered harmless by SP was 0.15 mm for the 460 and 670 HV specimens. However, even a slit with a depth of less than 0.15 mm could not be rendered harmless by SP for the 540 HV specimen. Considering the improvement in the torsional fatigue limit and the size of the surface defect that could be rendered harmless by SP, the 670 HV specimen is optimal for practical use.