Fiber optic sensor based on reflectivity configurations to detect heart rate

8th International Conference on Physics and its Applications

Yunianto, M.^1 ; Marzuki, A.^1 ; Riyatun, R.^1 ; Lestari, D.^1

Optic and Photonic Research Group, Physics Department, Sebelas Maret University, Indonesia^1

关键词: Heart-rate detection;    Intensity change;    Light dependent resistors (LDR);    Light emitting diode (LED);    Optical fiber systems;    Plastic optical fiber (POF);    Prototype sensor;    Reflector membranes;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/776/1/012110/pdf
DOI  :  10.1088/1742-6596/776/1/012110

来源: IOP

【 摘 要 】

Research of optical fiber-based heart rate detection sensor has been conducted using the reflection configurationon the thorax motion modified. Optical fiber used in this research was Plastic Optical Fiber (POF) with a diameter of 0.5. Optical fiber system is made with two pieces of fiber, the first fiber is to serve as a transmitter transmitting light from the source to the reflector membrane, the second fiber serves as a receiver. One of the endsfrom the two fibersis pressed and positioned perpendicular of reflector membrane which is placed on the surface of the chest. The sensor works on the principle of intensity changes captured by the receiver fiber when the reflector membrane gets the vibe from the heart. The light source used is in the form of Light Emitting Diode (LED) and Light Dependent Resistor (LDR) as a light sensor. Variations are performed on the reflector membrane diameter. The light intensity received by the detector increases along with the increasing width of the reflector membrane diameter. The results show that this sensor can detect the harmonic peak at a frequency of 1.5 Hz; 7.5 Hz; 10.5 Hz; and 22.5 Hz in a healthy human heart with an average value of Beat Per Minute (BPM) by 78 times, a prototype sensor that is made can work and function properly.