Optimization of dielectric matrix for ZnO nanowire based nanogenerators

16th International Conference on Micro and Nanotechnology for Power Generation and Energy Conversion Applications

物理学;能源学

Kannan, Santhosh^1 ; Parmar, Mitesh^1 ; Tao, Ran^1 ; Ardila, Gustavo^1 ; Mouis, Mireille^1

Univ. Grenoble Alpes, CNRS, IMEP-LaHC, Grenoble

F-38000, France^1

关键词: Aluminium oxide;    Dielectric layer;    Dielectric matrixes;    Hydrothermally;    Matrix materials;    Nanowires (NWs);    Output performance;    Zinc oxide (ZnO);   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/773/1/012071/pdf
DOI  :  10.1088/1742-6596/773/1/012071

来源: IOP

【 摘 要 】

This paper reports the role of selection of suitable dielectric layer in nanogenerator (NG) structure and its influence on the output performance. The basic NG structure is a composite material integrating hydrothermally grown vertical piezoelectric zinc oxide (ZnO) nanowires (NWs) into a dielectric matrix. To accomplish this study, three materials - poly methyl methacrylate (PMMA), silicon nitride (Si3N4) and aluminium oxide (Al2O3) are selected, processed and used as matrix dielectric in NGs. Scanning electron microscopy (SEM) analysis shows the well-aligned NWs with a diameter of 200 50 nm and length of 3.5 0.3 μm. This was followed by dielectric material deposition as a matrix material. After fabricating NG devices, the output generated voltage under manual and automatic bending were recorded, observed and analyzed for the selection of the best dielectric material to obtain an optimum output. The maximum peak-to-peak open-circuit voltage output for PMMA, Si3N4and Al2O3under manual bending was recorded as approximately 880 mV, 1.2 V and 2.1 V respectively. These preliminary results confirm the predicted effect of using more rigid dielectrics as matrix material for the NGs. The generated voltage is increased by about 70% using Si3N4or Al2O3, instead of a less rigid material as PMMA.