Characterization of piezoelectric device for implanted pacemaker energy harvesting

27th Micromechanics and Microsystems Europe Workshop

物理学;力学

Jay, Sunny^1 ; Caballero, Manuel^1 ; Quinn, William^1 ; Barrett, John^1 ; Hill, Martin^1

Cork Institute of Technology, Bishopstown, Cork, Ireland^1

关键词: 3D finite element model;    Displacement prediction;    Experimental analysis;    Fundamental equations;    Low-frequency energy;    Piezoelectric voltage;    Resonance frequencies;    Vibration frequency;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/757/1/012038/pdf
DOI  :  10.1088/1742-6596/757/1/012038

学科分类：力学，机械学

来源: IOP

【 摘 要 】

Novel implanted cardiac pacemakers that are powered by energy harvesters driven by the cardiac motion and have a 40 year lifetime are currently under development. To satisfy space constraints and energy requirements of the device, silicon-based MEMS energy harvesters are being developed in the EU project (MANpower1). Such MEMS harvesters for vibration frequencies below 50 Hz have not been widely reported. In this paper, an analytical model and a 3D finite element model (FEM) to predict displacement and open circuit voltage, validated through experimental analysis using an off-the-shelf low frequency energy harvester, are presented. The harvester was excited through constant amplitude sinusoidal base displacement over a range of 20 to 70 Hz passing through its first mode natural frequency at 47 Hz. At resonance both models predict displacements with an error of less than 2% when compared to the experimental result. Comparing the two models, the application of the experimentally measured damping ratio differs for accurate displacement prediction and the differences in symmetry in the measured and modelled displacement and voltage data around the resonance frequency indicate the two piezoelectric voltage models use different fundamental equations.