A novel design for a primary measurement standard for the quantity torque

8th Brazilian Congress on Metrology

Taccola, G.M.^1 ; Leão, R.J.^2

Center for Mechanical, Electrical and Fluid Flow Metrology, Institute for Technological Research, São Paulo

SP

05508-901, Brazil^1

Brazilian Synchrotron Light Laboratory, Brazilian Center for Research in Energy and Materials, Campinas

SP

13083-970, Brazil^2

关键词: Automatic machines;    Complex mechanical system;    Continuous torques;    Functional design;    Primary measurement standards;    Primary standards;    Reference measurements;    Torque standards;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/733/1/012019/pdf
DOI  :  10.1088/1742-6596/733/1/012019

来源: IOP

【 摘 要 】

Primary standards are established using a reference measurement procedure. Through the realization of the definition of a given quantity they provide traceability in the metrology chain. Most torque standards use calibrated weights linked to a lever arm to provide known torques in the rotational axis of the device. These standards do not succeed to provide continuous torque values because of limitation in weights combination and the intrinsic incremental steps of the technique. In automatic machines this can be overcome but it requires a complex mechanical system to operate. In designs that use movable weights along the lever arm the determination of the length of the lever arm is a large source of errors. Zeroing the torque standard also represents a major problem. An innovative and functional design that aims to solve the aforementioned disadvantages is presented.