Numerical Optimization of converging diverging miniature cavitating nozzles

9th International Symposium on Cavitation

Chavan, Kanchan^2 ; Bhingole, B.^1 ; Raut, J.^2 ; Pandit, A.B.^1

Department of Chemical Engineering, Institute of Chemical Technology, Mumbai, India^1

Unilever RandD Bangalore, 64 Main Road, Whitefield, Bangalore, India^2

关键词: CFD simulations;    Collapse pressure;    Converging-diverging nozzles;    Diverging section;    Nozzle dimensions;    Numerical optimizations;    Optimized geometries;    Radius of curvature;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/656/1/012138/pdf
DOI  :  10.1088/1742-6596/656/1/012138

来源: IOP

【 摘 要 】

The work focuses on the numerical optimization of converging diverging cavitating nozzles through nozzle dimensions and wall shape. The objective is to develop design rules for the geometry of cavitating nozzles for desired end-use. Two main aspects of nozzle design which affects the cavitation have been studied i.e. end dimensions of the geometry (i.e. angle and/or curvature of the inlet, outlet and the throat and the lengths of the converging and diverging sections) and wall curvatures(concave or convex). Angle of convergence at the inlet was found to control the cavity growth whereas angle of divergence of the exit controls the collapse of cavity. CFD simulations were carried out for the straight line converging and diverging sections by varying converging and diverging angles to study its effect on the collapse pressure generated by the cavity. Optimized geometry configurations were obtained on the basis of maximum Cavitational Efficacy Ratio (CER)i.e. cavity collapse pressure generated for a given permanent pressure drop across the system. With increasing capabilities in machining and fabrication, it is possible to exploit the effect of wall curvature to create nozzles with further increase in the CER. Effect of wall curvature has been studied for the straight, concave and convex shapes. Curvature has been varied and effect of concave and convex wall curvatures vis-à-vis straight walls studied for fixed converging and diverging angles.It is concluded that concave converging-diverging nozzles with converging angle of 20° and diverging angle of 5° with the radius of curvature 0.03 m and 0.1530 m respectively gives maximum CER. Preliminary experiments using optimized geometry are indicating similar trends and are currently being carried out. Refinements of the CFD technique using two phase flow simulations are planned.