Wind turbine wake interactions; results from blind tests

Wake Conference 2015

Krogstad, Per-Åge^1 ; Sætran, Lars^1

Department of Energy and Process Engineering, Norwegian University of Science and Technology NTNU, Trondheim, Norway^1

关键词: Axisymmetry;    Blind test;    Single models;    Tunnel environments;    Turbine performance;    Wind farm;    Wind turbine wakes;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/625/1/012043/pdf
DOI  :  10.1088/1742-6596/625/1/012043

来源: IOP

【 摘 要 】

Results from three "Blind test" Workshops on wind turbine wake modeling are presented. While the first "Blind test" (BT1, 2011) consisted of a single model turbine located in a large wind tunnel, the complexity was increased for each new test in order to see how various models performed. Thus the next "Blind test" (BT2, 2012) had two turbines mounted in-line. This is a crucial test for models intended to predict turbine performances in a wind farm. In the last "Blind test" (BT3, 2013) the two turbines were again mounted in-line, but offset sideways so that the rotor of the downstream turbine only intersected half the wake from the upstream turbine. This case produces high dynamic loads and strong asymmetry in the wake. For each "Blind test" the turbine geometry and wind tunnel environment was specified and the participants were asked to predict the turbine performances, as well as the wake development to five diameters downstream of the second turbine. For the first two tests axisymmetry could be assumed if the influence of the towers was neglected. This was not possible in BT3 and therefore only fully 3D methods could be applied. In all tests the prediction scatter was surprisingly high.