Method to improve the accuracy of the geometrical parameters measurement in stereoscopic AOTF-based spectral imagers

International Scientific Seminars on "Fundamental and Applied Problems of Photonics and Condensed Matter Physics"

Gorevoy, A.V.^1 ; Machikhin, A.S.^2

Bauman Moscow State Technical University, 5/1, 2nd Baumanskaya street, Moscow

105005, Russia^1

Scientific and Technological Center of Unique Instrumentation of Russian, Academy of Sciences, Butlerova street, 15, Moscow

117342, Russia^2

关键词: 3D coordinates;    Arbitrary shape;    Area measurement;    Design documentation;    Geometrical measurement;    Major factors;    Priori information;    Spectral imagers;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/584/1/012004/pdf
DOI  :  10.1088/1742-6596/584/1/012004

来源: IOP

【 摘 要 】

The problem of non-contact geometrical measurements by the stereoscopic spectral AOTF-based imagers is considered. Major factors contributing to the measurement error are analyzed for the first time. Expressions are derived for area measurement inaccuracy on arbitrary shape surfaces, caused by measurement errors of individual points' 3D coordinates with and without a priori information about surface shape. Verification of the obtained expressions with the real experimental data showed that area measurement error for a complex figure, given by the set of points, is caused mainly by ignoring the fact that these points belong to the surface. It is shown that the use of a priori information about investigated surface shape, which is often available from the design documentation, in many cases would radically improve the accuracy of surface defects area measurement. The presented results can be effectively used for the development of new 3D spectral imagers and modernization of existing ones.