Modeling chemical vapor deposition of silicon dioxide in microreactors at atmospheric pressure

3rd International Conference on Mathematical Modeling in Physical Sciences

物理学;数学

Konakov, S.A.^1 ; Krzhizhanovskaya, V.V.^1,2,3

St. Petersburg State Polytechnical University, St. Petersburg

195251, Russia^1

University of Amsterdam, Amsterdam

1098 XH, Netherlands^2

ITMO University, St. Petersburg

197101, Russia^3

关键词: Chemical vapor depositions (CVD);    Computational fluid dynamics modeling;    Design and optimization;    Energy balance equations;    Microreactor technology;    Modeling for simulations;    Technological parameters;    Tetraethyl orthosilicates;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/574/1/012145/pdf
DOI  :  10.1088/1742-6596/574/1/012145

来源: IOP

【 摘 要 】

We developed a multiphysics mathematical model for simulation of silicon dioxide Chemical Vapor Deposition (CVD) from tetraethyl orthosilicate (TEOS) and oxygen mixture in a microreactor at atmospheric pressure. Microfluidics is a promising technology with numerous applications in chemical synthesis due to its high heat and mass transfer efficiency and well-controlled flow parameters. Experimental studies of CVD microreactor technology are slow and expensive. Analytical solution of the governing equations is impossible due to the complexity of intertwined non-linear physical and chemical processes. Computer simulation is the most effective tool for design and optimization of microreactors. Our computational fluid dynamics model employs mass, momentum and energy balance equations for a laminar transient flow of a chemically reacting gas mixture at low Reynolds number. Simulation results show the influence of microreactor configuration and process parameters on SiO2 deposition rate and uniformity. We simulated three microreactors with the central channel diameter of 5, 10, 20 micrometers, varying gas flow rate in the range of 5-100 microliters per hour and temperature in the range of 300-800 °C. For each microchannel diameter we found an optimal set of process parameters providing the best quality of deposited material. The model will be used for optimization of the microreactor configuration and technological parameters to facilitate the experimental stage of this research.