Portable device for the detection of nitro-explosives based on optical properties of sensor's material

International Congress on Energy Fluxes and Radiation Effects

Baranova, A.A.^1 ; Khokhlov, K.O.^1

Ural Federal University, Yekaterinburg, Russia^1

关键词: Excitation sources;    Luminescence band;    Luminescence intensity;    Luminescence spectrum;    Luminescent property;    Multiple operating modes;    Photoluminescence spectrum;    Steady-state luminescence;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/552/1/012034/pdf
DOI  :  10.1088/1742-6596/552/1/012034

来源: IOP

【 摘 要 】

The aim of this study was to design a device for explosives detection. The study design is based on excited steady-state luminescence quenching registration. Sensor's material luminescence intensity reduction occurs due to an interaction of explosives vapours contained in the air. The decrease rate of the luminescence intensity indicates the concentration of vapours. To study the luminescent properties of the sensor element, its luminescence spectra excited by photons with energies in the range 280 - 425 nm were measured. The excitation photoluminescence spectra for luminescence bands of the sensor element were also measured. Excitation source was light emitting diode (375 nm) and luminescent signal receiver was a photodiode (430 - 650 nm) in device designed. The device is operated under control of a program. The algorithm provides multiple operating modes (configuration, calibration, measurement etc.). Thus this device is referred to the class of devices with increased sensitivity to the explosives vapors. The advantages of device are autonomic power, small weight and sizes, simplicity of device operation for measurements.