Modelling of flow with cavitation in centrifugal pump

21st Fluid Mechanics Conference

物理学;力学

Homa, D.^1 ; Wróblewski, W.^1

Institute of Power Engineering and Turbomachinery, Silesian University of Technology, Gliwice Konarskiego Street 18, Poland^1

关键词: Cavitation characteristics;    Cavitation conditions;    Local pressure drop;    Modelling of flows;    Noise and vibration;    Saturation pressure;    Single phase fluids;    Transient calculation;   

Others  :  https://iopscience.iop.org/article/10.1088/1742-6596/530/1/012032/pdf
DOI  :  10.1088/1742-6596/530/1/012032

学科分类：力学，机械学

来源: IOP

【 摘 要 】

The paper concerns flow modelling in centrifugal pump with special consideration of cavitation phenomena. Cavitation occurs when local pressure drops below the saturation pressure according to the temperature of the flow. Vapour bubbles are created and then they flow through the areas with higher pressure. The bubbles collapse rapidly generating pressure wave, noise and vibration. Working under cavitation condition is very dangerous to a pump and can significantly shorten its lifetime. The investigated centrifugal pump consists of three two-flow rotors and stators working on a single shaft. The modelling process started with grid independence study. When the grid was chosen, the pump performance curve was obtained using the single phase fluid model. Next, using the results from pump performance curve calculations, the cavitation characteristic was obtained. The constant capacity was held when the pressure at the inlet was reduced. The two - phase model was used with Zwart cavitation model. The results indicate that the pump work in safe range of parameters. The analysis also provides wide range of information about the areas of vapour appearance. The most endangered regions are leading edges of rotor. When pressure at the inlet drops to about one third of pressure that calculations started from the cavitation cloud appears in whole rotor. The intense of vapour bubbles creation is greater near the shroud of the pump, rather than near the hub. As cavitation is strongly unsteady phenomena, the transient calculations were performed to check if the results are close to those obtained using the steady state type. The differences are not significant.