Effect of Particle Pre-treatment on Physical and Mechanical Properties of Particleboard Made from Oil Palm Trunk

Humanosphere Science School 2017; 7th International Symposium for a Sustainable Humanosphere

地球科学;经济学

Hartono, R.^1 ; Iswanto, A.H.^1 ; Sucipto, T.^1 ; Lubis, K.M.^1

Faculty of Forestry, Universitas Sumatera Utara, Kampus USU, Jl. Tridharma Ujung No 1, Medan

20155, Indonesia^1

关键词: Cold and hot waters;    Modulus of rupture;    Particle immersion;    Physical and mechanical properties;    Pressing temperature;    Pretreatment conditions;    Thickness swelling;    Urea formaldehyde;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/166/1/012006/pdf
DOI  :  10.1088/1755-1315/166/1/012006

来源: IOP

【 摘 要 】

Oil palm trunk can be used as raw material for particleboard. On the other hand, oil palm trunk contains many extractive substances, which can disturb the adhesion of particleboard. The objective of this research was to the effect of particle-pretreatment on particleboard properties made from oil palm trunk. The particle had been pre-treated with cold water (24, 48, and 72 hours) and hot water (1, 2 and 3 hours). The particles were dried to 3% in the oven. Board were made with size 30 (length) x 30 (width) x 1 cm (thick) with density target of 0.7 g/cm3. Particleboard was made bonded urea formaldehyde with pressing temperature of 130°C and pressure of 25 kg/cm2 for 10 minutes. Control (particleboard without pre-treatment) was also produced. The board properties were tested in accordance with SNI 03-2105-2006. The results showed that particle pre-treatment improved physical and mechanical properties of particleboard. Pre-treatment (immersion in cold and hot water) decreased the moisture content (MC) and thickness swelling (TS) and increased modulus of rupture (MOR), modulus of elasticity (MOE) and Internal Bond (IB) value. The value of density, MC, MOR and IB fulfilled the SNI 03-2105-2006 standard, while the all MOE and TS value have not fulfilled the standard. The best pre-treatment condition was particle immersion into hot water for 2 hours.