Treatment of high salinity organic wastewater by membrane electrolysis

3rd International Conference on Energy Equipment Science and Engineering

Dongfang, Shen^1 ; Jinghuan, Ma^1,2 ; Ying, Liu^1 ; Chenguang, Zhao^1

Department of Environmental and Chemical Engineering, Tianjin Polytechnic University, Tianjin, China^1

Tianjin Hai Ze Hui Technology Co., Ltd., Tianjin, China^2

关键词: Calcium and magnesiums;    Cation exchange membranes;    Different operating conditions;    Electrolytic solution;    Mass transfer efficiency;    Membrane electrolysis;    Surface contaminations;    X-ray energy dispersive spectrometers;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/128/1/012141/pdf
DOI  :  10.1088/1755-1315/128/1/012141

来源: IOP

【 摘 要 】

The effects of different operating conditions on the treatment of electrolytic wastewater were investigated by analyzing the removal rate of ammonia and COD before and after wastewater treatment by cation exchange membrane. Experiment shows that as the running time increases the electrolysis effect first increases after the smooth. The removal rate of ammonia will increase with the increase of current density, and the removal rate of COD will increase first and then decrease with the increase of current density. The increase of the temperature of the electrolytic solution will slowly increase the COD removal rate to saturation, but does not affect the removal of ammonia nitrogen. When the flow rate is less than 60L / h, the change of influent flow rate will not affect the removal of ammonia nitrogen, but the effect on COD is small, which will increase and decrease slightly. After the experiment, the surface of the cation exchange membrane was analyzed by cold field scanning electron microscopy and X-ray energy dispersive spectrometer. The surface contamination and the pollutant were determined. The experimental results showed that the aggregates were mainly chlorinated Sodium, calcium and magnesium inorganic salts, which will change the morphology of the film to reduce porosity, reduce the mass transfer efficiency, affecting the electrolysis effect.