Experimental Study on Treatment of Dyeing Wastewater by Activated Carbon Adsorption, Coagulation and Fenton Oxidation

1st International Global on Renewable Energy and Development

Xiaoxu, S.U.N.^1 ; Jin, X.U.^1 ; Xingyu, L.I.^1

Nanjing Institute of Technology, China^1

关键词: Activated carbon adsorption;    Adsorption reaction;    Chemical oxidation;    Coagulation process;    Decolorization rates;    Dyeing wastewater;    Optimum conditions;    Reactive Brilliant Blue X-BR;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/100/1/012199/pdf
DOI  :  10.1088/1755-1315/100/1/012199

来源: IOP

【 摘 要 】

In this paper dyeing waste water was simulated by reactive brilliant blue XBR, activated carbon adsorption process, coagulation process and chemical oxidation process were used to treat dyeing waste water. In activated carbon adsorption process and coagulation process, the water absorbance values were measured. The CODcr value of water was determined in Fenton chemical oxidation process. Then, the decolorization rate and COD removal rate were calculated respectively. The results showed that the optimum conditions of activated carbon adsorption process were as follows: pH=2, the dosage of activated carbon was 1.2g/L, the adsorption reaction time was 60 min, and the average decolorization rate of the three parallel experiments was 85.30%. The optimum conditions of coagulation experiment were as follows: pH=8∼9, PAC dosage was 70mg/L, stirring time was 20min, standing time was 45min, the average decolorization rate of the three parallel experiments was 74.48%. The optimum conditions for Fenton oxidation were Fe2+0.05g/L, H2O2(30%) 14mL/L, pH=3, reaction time 40min. The average CODcr removal rate was 69.35% in three parallel experiments. It can be seen that in the three methods the activated carbon adsorption treatment of dyeing wastewater was the best one.