Study of abrasive resistance of foundries models obtained with use of additive technology

Innovations and Prospects of Development of Mining Machinery and Electrical Engineering

矿业工程;电工学

Ol'Khovik, Evgeniy^1

Admiral Makarov State University of Maritime and Inland Shipping, 5/7 Dvinskaya St., Saint-Petersburg, Russia^1

关键词: Abrasive resistance;    Additive technology;    Foundry model;    Manufacturing techniques;    Plastic models;    Qualitative research;    Two-component coatings;    Vibration loads;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/87/9/092019/pdf
DOI  :  10.1088/1755-1315/87/9/092019

来源: IOP

【 摘 要 】

A problem of determination of resistance of the foundry models and patterns from ABS (PLA) plastic, obtained by the method of 3D printing with using FDM additive technology, to abrasive wear and resistance in the environment of foundry sand mould is considered in the present study. The description of a technique and equipment for tests of castings models and patterns for wear is provided in the article. The manufacturing techniques of models with the use of the 3D printer (additive technology) are described. The scheme with vibration load was applied to samples tests. For the most qualitative research of influence of sandy mix on plastic, models in real conditions of abrasive wear have been organized. The results also examined the application of acrylic paintwork to the plastic model and a two-component coating. The practical offers and recommendation on production of master models with the use of FDM technology allowing one to reach indicators of durability, exceeding 2000 cycles of moulding in foundry sand mix, are described.