Study of the properties of flux cored wire of Fe-C-Si-Mn-Cr-Mo-Ni-V-Co system for the strengthening of nodes and parts of equipment used in the mineral mining

International Scientific and Research Conference on Knowledge-based Technologies in Development and Utilization of Mineral Resources 2017

矿业工程;地球科学

Gusev, A.I.^1 ; Kozyrev, N.A.^1 ; Usoltsev, A.A.^1 ; Kryukov, R.E.^1 ; Osetkovsky, I.V.^1

Siberian State Industrial University, 42 Kirova Street, Novokuznetsk

654007, Russia^1

关键词: Austenite grain;    Deposited layer;    Different operating conditions;    Flux-cored wire;    Laboratory conditions;    Mineral minings;    Powder surfacing;    Welding tractors;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/84/1/012018/pdf
DOI  :  10.1088/1755-1315/84/1/012018

来源: IOP

【 摘 要 】

The effect of the introduction of vanadium and cobalt into the charge of the powder surfacing wire of Fe-C-Si-Mn-Cr-Mo-Ni system is studied. In the laboratory conditions, the samples of flux cored wires were produced. The surfacing made by the prepared wire was produced under the flux AN-26C, on the plates of steel St3 in 6 layers with the help of ASAW-1250 welding tractor. Reduction of carbon content in the deposited layer to 0.19-0.2% with simultaneous change in the content of chromium, nickel, molybdenum and other elements present in it contributes to the enlargement of the martensite needles and the increase in the size of the former austenite grain. The obtained dependences of hardness of the deposited layer and its wear resistance on the mass fraction of elements, included in the composition of powder wires of the proposed system, can be used to predict the hardness of the welded layer and its wear resistance under different operating conditions for mining equipment and coal mining equipment.