2-D Resistivity Assessment of Subsurface Characterization and its Engineering and Environmental Implications at SiLC

Southeast Asian Conference on Geophysics

Nordiana, M.M.^1 ; Azwin, I.N.^1 ; Saad, Rosli^1 ; Ying Jia, Teoh^1 ; Anderson, A.B.^1 ; Tonnizam, Edy^2 ; Taqiuddin Zakaria, Muhamad^1

School of Physics, Universiti Sains Malaysia, Penang

11800, Malaysia^1

Department of Geotechnics and Transportation, Faculty of Civil Engineering, Universiti Teknologi Malaysia, Skudai, UTM Johor

81310, Malaysia^2

关键词: Construction sites;    Electrode spacing;    Environmental implications;    Foundation depths;    Geophysical characterization;    High rise building;    Pole-dipole arrays;    Subsurface characterizations;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/62/1/012011/pdf
DOI  :  10.1088/1755-1315/62/1/012011

来源: IOP

【 摘 要 】

The role of geophysics in Environmental Earth Sciences and Engineering is considered. In the developing era, geophysics has mainly contributed in investigation of new constructions such as tunnels, road, dams and high-rise buildings. This study was carried out to assess the foundation depths around a construction site in the Southern Industrial & Logistics Clusters (SiLC), Nusajaya, Johor using 2-D resistivity method. The 2-D resistivity method was carried out with a view to characterize different subsurface geological and to provide the engineering and environmental geophysical characterization of the study area. Measurements of eight 2-D resistivity profile using Pole-dipole array with 2 m minimum electrode spacing was taken with the use of ABEM Terrameter SAS4000 and ES10-64C selector. The results are presented as inversion model resistivity with the outline of the survey line. The inversion model resistivity from L1-L8 obtained is characterized by resistivity range of 1-8000 ohm-m. This range indicates the occurrence of silt, clay, sandy clay and sand whose ranges are; 10-100 ohm-m, 1-100 ohm-m, 100-800 ohm-m and 100-3000 ohm-m respectively. However, there was a boulder with range of >5000 ohm-m and saturated zone (1-20 ohm-m) which may indicate the weak zones of the study area. The 2-D resistivity method is not intended to replace borings, except in specific cases where information gathered would be sufficient to address the intended engineering and environmental purpose.