Environmental Aspects Of The Green Surface Plastic Deformation Technology Of Car Parts

Ecology and safety in the technosphere: current problems and solutions

Grigoriev, S.N.^1 ; Bobrovskij, N.M.^2 ; Bobrovskij, I.N.^2 ; Melnikov, P.A.^2 ; Lukyanov, A.A.^2

Moscow State Technological University Stankin, Vadkovskij per. 1, Moscow

127055, Russia^1

Togliatti State University, Belorusskaya st. 14, Togliatti

445667, Russia^2

关键词: Car parts;    Dry processing;    Environmental aspects;    Human health;    Impact on the environment;    Industrial companies;    Main tasks;    Surface plastic deformation;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/50/1/012015/pdf
DOI  :  10.1088/1755-1315/50/1/012015

来源: IOP

【 摘 要 】

Foreign and domestic experience in development of dry processing technologies are considered. The results of the introduction of dry processing technologies (cutting, boring, milling, drilling) on the industrial companies in Germany are given. The negative impact on the environment and human health is shown. The possible ways of leakage of lubricoolant components in the atmosphere and soil are considered. Lubricoolants are considered as a required permanent component. Three main tasks for lubricoolant: cooling, lubricating and chip disposal are discribed.