Cavitation Influence in 1D Part-load Vortex Models

28th IAHR symposium on Hydraulic Machinery and Systems

Dörfler, P.K.^1

Hydro Adviser LLC, Zurich, Switzerland^1

关键词: Cavitation compliance;    Conventional methods;    Distributed parameter;    Dynamic phenomena;    Hydraulic transients;    Low-frequency pulsations;    Non-condensable gas;    Part load operation;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/49/5/052003/pdf
DOI  :  10.1088/1755-1315/49/5/052003

来源: IOP

【 摘 要 】

Residual swirl in the draft tube of Francis turbines may cause annoying low- frequency pulsation of pressure and power output, in particular during part-load operation. A 1D analytical model for these dynamic phenomena would enable simulation by some conventional method for computing hydraulic transients. The proper structure of such a model has implications for the prediction of prototype behaviour based on laboratory tests. The source of excitation as well as the dynamic transmission behaviour of the draft tube flow may both be described either by lumped or distributed parameters. The distributed version contains more information and, due to limited possibilities of identification, some data must be estimated. The distributed cavitation compliance is an example for this dilemma. In recent publications, the customary assumption of a constant wave speed has produced dubious results. The paper presents a more realistic model for distributed compressibility. The measured influence of the Thoma number is applied with the local cavitation factor. This concept is less sensitive to modelling errors and explains both the Thoma and Froude number influence. The possible effect of the normally unknown non-condensable gas content in the vortex cavity is shortly commented. Its measurement in future tests is recommended. It is also recommended to check the available analytical vortex models for possible dispersion effects.