High load vortex oscillations developed in Francis turbines

28th IAHR symposium on Hydraulic Machinery and Systems

Rodriguez, D.^1 ; Rivetti, A.^1 ; Lucino, C.^1

Laboratory of Hydromechanics, National University of la Plata, La Plata, Argentina^1

关键词: Axisymmetric vortex;    Dynamic behaviors;    Good correlations;    Hydraulic behavior;    Numerical flow simulations;    Oscillation frequency;    Pressure pulsation;    Self excited oscillation;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/49/8/082006/pdf
DOI  :  10.1088/1755-1315/49/8/082006

来源: IOP

【 摘 要 】

Francis turbines operating at high load conditions produce a typical flow pattern in the draft tube cone characterized by the presence of an axisymmetric central vortex. This central cavity could become unstable, generating synchronic pressure pulsations, usually called self-excited oscillations, which propagate into the whole machine. The on-set and size of the central vortex cavity depend on the geometry of the runner and draft tube and on the operating point as well. Numerical flow simulations and model tests allow for the characterization of the different flow patterns induced by each particular Francis turbine design and, when studied in combination with the hydraulic system, including the intake and penstock, could predict the prototype hydraulic behavior for the complete operation zone. The present work focuses the CFD simulation on the development and dynamic behavior of the central axisymmetric vortex for a medium-head Francis turbine operating at high load conditions. The CFD simulations are based in two-phase transient calculations. Oscillation frequencies against its cavity volume development were obtained and good correlation was found with experimental results.