Determination of Slake Durability Index (Sdi) Values on Different Shape of Laminated Marl Samples

World Multidisciplinary Earth Sciences Symposium 2016

Ankara, Hüseyin^1 ; Çiçek, Fatma^1 ; Deniz, Ismail Talha^1 ; Uçak, Emre^1 ; Kandemir, Süheyla Yerel^1

Eskiehir Osmangazi University, Department of Mining Engineering, Eskiehir, Turkey^1

关键词: Different shapes;    Disintegration characteristics;    Geo-engineering problems;    Irregular sample;    Irregular shape;    Sample preparation methods;    Slake durability indices;    Slaking process;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/44/2/022006/pdf
DOI  :  10.1088/1755-1315/44/2/022006

来源: IOP

【 摘 要 】

The slake durability index (SDI) test is widely used to determine the disintegration characteristic of the weak and clay-bearing rocks in geo-engineering problems. However, due to the different shapes of sample pieces, such as, irregular shapes displayed mechanical breakages in the slaking process, the SDI test has some limitations that affect the index values. In addition, shape and surface roughness of laminated marl samples have a severe influence on the SDI. In this study, a new sample preparation method called Pasha Method was used to prepare spherical specimens from the laminated marl collected from Seyitomer collar (SLI). Moreover the SDI tests were performed on equal size and weight specimens: three sets with different shapes were used. The three different sets were prepared as the test samples which had sphere shape, parallel to the layers in irregular shape, and vertical to the layers in irregular shape. Index values were determined for the three different sets subjected to the SDI test for 4 cycles. The index values at the end of fourth cycle were found to be 98.43, 98.39 and 97.20 %, respectively. As seen, the index values of the sphere sample set were found to be higher than irregular sample sets.