Energy-saving compression valve of the rock drill

19th International Scientific Symposium in honor of Academician M.A. Usov "Problems of Geology and Subsurface Development"

Glazov, A.N.^1 ; Efanov, A.A.^1 ; Aikina, T.Yu.^1

Institute of High Technology Physics, National Research Tomsk Polytechnic University, 30 Lenin Ave., Tomsk

634050, Russia^1

关键词: Air consumption;    Air flow-rate;    Cycle time;    Low-energy;    New mechanisms;    Noise levels;    Operating cycle;    Working chambers;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/27/1/012055/pdf
DOI  :  10.1088/1755-1315/27/1/012055

来源: IOP

【 摘 要 】

The relevance of the research is due to the necessity to create pneumatic rock drills with low air consumption. The article analyzes the reasons for low efficiency of percussive machines. The authors state that applying a single distribution body in the percussive mechanism does not allow carrying out a low-energy operating cycle of the mechanism. Using the studied device as an example, it is substantiated that applying a compression valve with two distribution bodies separately operating the working chambers makes it possible to significantly reduce the airflow. The authors describe the construction of a core drill percussive mechanism and the operation of a compression valve. It is shown that in the new percussive mechanism working chambers are cut off the circuit by the time when exhaust windows are opened by the piston and air is not supplied into the cylinder up to 20% of the cycle time. The air flow rate of the new mechanism was 3.8 m3/min. In comparison with the drill PK-75, the overall noise level of the new machine is lower by 8-10 dB, while the percussive mechanism efficiency is 2.3 times higher.