Numerical analysis of rotating stall instabilities of a pump- turbine in pump mode

27th IAHR Symposium on Hydraulic Machinery and Systems

Xia, L.S.^1 ; Cheng, Y.G.^1 ; Zhang, X.X.^1 ; Yang, J.D.^1

State Key Laboratory of Water Resources and Hydropower Engineering Science, Wuhan University, Wuhan

430072, China^1

关键词: CFD simulations;    Complicated flow;    Design condition;    Efficiency characteristic;    Energy discharge;    Impeller rotation;    Separation zone;    Structure information;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/22/3/032020/pdf
DOI  :  10.1088/1755-1315/22/3/032020

来源: IOP

【 摘 要 】

Rotating stall may occur at part load flow of a pump-turbine in pump mode. Unstable flow structures developing under stall condition can lead to a sudden drop of efficiency, high dynamic load and even cavitation. CFD simulations on a pump-turbine model in pump mode were carried out to reveal the onset and developed mechanisms of these unstable flow phenomena at part load. The simulation results of energy-discharge and efficiency characteristics are in good agreement with those obtained by experiments. The more deviate from design conditions with decreasing flow rate, the more flow separations within the vanes. Under specific conditions, four stationary separation zones begin to progress on the circumference, rotating at a fraction of the impeller rotation rate. Rotating stalls lead to the flow in the vane diffuser channels alternating between outward jet flow and blockage. Strong jets impact the spiral casing wall causing high pressure pulsations. Severe separations of the stall cells disturb the flow inducing periodical large amplitude pressure fluctuations, of which the intensity at different span wise of the guide vanes is different. The enforced rotating nonuniform pressure distributions on the circumference lead to dynamic uniform forces on the impeller and guide vanes. The results show that the CFD simulations are capable to gain the complicated flow structure information for analysing the unstable characteristics of the pump mode at part load.