Calculating the process of straightening low-stiff cylindrical parts by cross-rolling with smooth plates

International Scientific Conference «AGRITECH-2019: Agribusiness, Environmental Engineering and Biotechnologies»

农业科学;生态环境科学;生物科学

Zykova, Marina^1 ; Zaides, Semen^2 ; Bobrovskij, Nikolaj^3 ; Quang, Le Hong^2 ; Levitskih, Olesja^4 ; Petr, Salov^5 ; Lukyanov, Aleksey^4

Moscow State Technological University Stankin, Moscow, Russia^1

Irkutsk National Research Technical University, Irkutsk, Russia^2

Togliatti State University, Togliatti, Russia^3

Samara Scientific Center of Russian Academy of Science, Samara, Russia^4

Chuvash State University, Cheboksary, Russia^5

关键词: Ansys workbenches;    Cross rolling;    Mechanical processing technology;    Operating voltage;    Stress state;    Surface plastic deformation;    Transverse bending;    Transverse rolling;   

Others  :  https://iopscience.iop.org/article/10.1088/1755-1315/315/5/052044/pdf
DOI  :  10.1088/1755-1315/315/5/052044

来源: IOP

【 摘 要 】

To restore the shape of curved low-stiff cylindrical parts such as shafts and axles, the process of straightening by transverse bending is considered with subsequent hardening by the method of surface plastic deformation based on the transverse rolling of the cylindrical part with flat plates. The stress states of parts during editing are determined using the Ansys Workbench software package. The results of the distribution of the intensity of operating voltages and residual stresses over the cross section of the cylinder, depending on the absolute compression, are presented. The process in question can be implemented without the use of environmentally hazardous lubricating cooling technological means, which makes it possible to attribute it in the future to one of the types of green mechanical processing technologies.