Study of boundary conditions for design of new types of fibre concrete energy dissipators in hydraulic structures

FIBRE CONCRETE 2019

土木建筑工程

Foumpaur, P.^1 ; Kapar, T.^1 ; Králík, M.^1 ; Zukal, M.^1

Department of Hydraulic Structures, Faculty of Civil Engineering, CTU in Prague, Thákurova 7, Prague 6

166 29, Czech Republic^1

关键词: Efficient designs;    Fibre concrete;    Flood waters;    Rainfall event;    Scientific community;    Setting parameters;    Traditional structures;    Water inflows;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/596/1/012031/pdf
DOI  :  10.1088/1757-899X/596/1/012031

学科分类：土木及结构工程学

来源: IOP

【 摘 要 】

The paper describes experiments aimed at setting parameters for an efficient design of new types and shapes of energy dissipators on chutes of dam spillways. During major rainfall events, large water inflows into the reservoir induce a rise in the reservoir level, and a spillway system must be installed to spill safely the flood waters. Two key challenges during the spillway design are conveyance and energy dissipation. Energy dissipation on dam spillways can be achieved by a range of dissipator designs. One type of spillway is a block ramp. Block ramps are hydraulic structures which are often used in practical applications to assure a correct balance between hydraulic functioning and the environmental impact. One of the main peculiarities of this approach is the capacity to dissipate a larger energy amount than other traditional structures. Thus, significant efforts were spent by the scientific community around the world in order to optimize their energy dissipation efficiency. The use of fibre concrete for the design of reinforced block ramps can improve their resistance significantly. The presented experiments describe the boundary condition for the design of new fibre concrete dissipators based on the measurements performed on reinforced block ramps.