Influences of Laser Remelting on Microstructure and Thermal Shock Resistance of Al2O3-13wt.%TiO2 Coatings Deposited by Plasma Spraying

5th Annual International Workshop on Materials Science and Engineering

Wang, Dongsheng^1^2

College of Mechanical Engineering, Tongling University, Tongling

244000, China^1

Key Laboratory of Construction Hydraulic Robots of Anhui Higher Education Institutes, Tongling University, Tongling

244000, China^2

关键词: Composite ceramic coating;    Failure mechanism;    Heat-conductivity coefficients;    Isometric crystals;    Laser re-melting;    Plasma-sprayed coatings;    Thermal shock resistance;    X ray diffractometers;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/585/1/012021/pdf
DOI  :  10.1088/1757-899X/585/1/012021

来源: IOP

【 摘 要 】

Al2O3-13wt.%TiO2 composite ceramic coatings were prepared by plasma spraying and laser remelting. Morphology, microstructure and phase composition were analyzed by scanning electron microscope (SEM) and X-ray diffractometer (XRD). Meanwhile, effects of laser remelting on thermal shock resistance of plasma-sprayed coatings were investigated and the thermal shock failure mechanism of coatings were discussed. Results demonstrate that after laser remelting, particles on the ceramic coating are refined and the lamellar structure disappears, thus increasing density and getting a remelting coating basically without defects like cracks. Laser remelting metastable phase γ-Al2O3 is transformed into a stable phase α-Al2O3. Due to low heat conductivity coefficient of ceramic materials, it is impossible to remelt the whole ceramic coating at laser remelting. An isometric crystal remelted zone with small grains, a sintered zone and a lamellar remained plasma-sprayed zone are formed on the remelting ceramic coating. Compared with plasma-sprayed coating, the laser-remelted coating has better thermal shock resistance. The thermal shock failure form of ceramic coating deposited by plasma spraying is basically corner peeling, while the thermal shock failure forms of laser-remelted ceramic coating includes both corner peeling and considerable local peelings in the center. Influences of laser remelting on thermal shock resistance of coating are mainly manifested as reduced initial failure resistance of coatings, decelerated crack propagation on coatings and changing failure mode of coatings.