Grinding closed circuit in centrifugal grinding unit

International Conference on Mechanical Engineering, Automation and Control Systems 2018

Sevostyanov, V.S.^1 ; Uralskij, V.I.^1 ; Uralskij, A.V.^1 ; Sinitsa, E.V.^1 ; Uralskaja, L.S.^1

Belgorod State Technological University Named after V.G.Shoukhov, 46, Kostyukov Str., Belgorod

308012, Russia^1

关键词: Design parameters;    Finished products;    Grinding circuits;    Input and outputs;    Solidworks software;    Technical development;    Technological modules;    Working chambers;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/560/1/012128/pdf
DOI  :  10.1088/1757-899X/560/1/012128

来源: IOP

【 摘 要 】

The article presents scientific and technical developments on the creation of a technological module of a closed grinding circuit, the design of which allows improving the quality of the finished product, as well as improving the performance of the grinding unit. The process of organizing a closed cycle using a centrifugal air-through separator with two separation zones is described. The influence of the design parameters of the input and output elements of the pipes on the gas flow rate in the working chambers of the grinding unit using the SolidWorks software in the FlowSimulation module has been studied.