Warpage Optimisation On The Front Panel Housing Moulded By Acrylonitrile Butadiene Styrene (ABS) (Virgin and Recycle) Material: A Review

Joint Conference on Green Engineering Technology & Applied Computing 2019

工业技术（总论）;计算机科学

Hidayah Mohamad Huzaim, Nurul^1 ; Zamree Abd Rahim, Shayfull^1^2 ; Roslan, Norshahira^1 ; Aisyah Miza Ahmad Tamizi, Nur^1

School of Manufacturing Engineering, Universiti Malaysia Perlis, KampusTetapPauh Putra, Perlis, Arau

02600, Malaysia^1

Green Design and Manufacture Research Group, Center of Excellence Geopolymer and Green Technology (CEGeoGTech), Universiti Malaysia Perlis, Kangar, Perlis

01000, Malaysia^2

关键词: Acrylonitrile butadiene styrene;    Effect of parameters;    Injection molding process;    Optimisations;    Plastic consumption;    Plastic molding;    Plastic wastes;    Recycled materials;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/551/1/012025/pdf
DOI  :  10.1088/1757-899X/551/1/012025

来源: IOP

【 摘 要 】

Injection molding process is well known in plastic molding industries. The development of this process had causes the materials used to mold plastic product to increase. However, this downside of this large amount of plastic consumption also leads to the fact that plastic waste fills the landfill. This cause researches on recycling plastic to increase. Even though injection molding process has many advantages, but the occurrence of defects on plastic part molded is one of the most important issues to be resolved. Warpage defect is one of the defect that normally occurred on molded part. This paper presents a review of the current research on the outlook of injection molding process and the effect of parameter processing on plastic molded part. The effect of parameter processing on mechanical properties of plastic mold parts with a mixture of virgin and recycled material has been numerously studied. However, studies on the physical appearance and quality of plastic mold parts by a mixture of virgin and recycled material have yet to be explored.