Noise reduction in near infrared-based glucose concentration measurement sensor

4th International Conference on Science, Technology and Interdisciplinary Research

工业技术（总论）;自然科学（总论）

Prawiroredjo, K.^1 ; Julian, E.S.^1 ; Tjahjadi, G.^1

Electrical Engineering Department, Faculty of Industrial Technology, Trisakti University, Kampus A, Jl. Kyai Tapa No. 1, Jakarta

11440, Indonesia^1

关键词: Blood glucose level;    Glucose concentration;    Glucose concentration measurements;    Glucose solution;    High-frequency noise;    Near infrared light;    Photodiode sensors;    Voltage signals;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/532/1/012010/pdf
DOI  :  10.1088/1757-899X/532/1/012010

来源: IOP

【 摘 要 】

This paper describes the method of measuring glucose concentrations in solution using near infrared light (NIR) and photodiode sensor. A sensitive and accurate non invasive blood glucose level sensor is our main concern in designing this device. The sensor consists of a transimpedance amplifier, a notch filter and a low pass filter to reduce high frequency noise and 50 Hertz noise from the power line induction. Light Emitting Diode (LED) with 1450 nm wavelength is used as a light source and a photodiode is used as a sensor to sense this wavelength. The NIR light received by the photodiode after passing glucose solution is converted to voltage signal and filtered to determine the output voltage. The measurement results show that the filters reduced the AC voltage or noise signal under 100 mV and the DC voltage tended to decrease as glucose concentration increase until 700 mg/dL.