Frequency Response Function Based Updating of a Laser Spot Welded Structure using Synthesised Frequency Response Function

1st South Aceh International Conference on Engineering and Technology

工业技术（总论）

Mohd Zin, M.S.^1 ; Abdul Rani, M.N.^1 ; Yunus, M.A.^1 ; Wan Iskandar Mirza, W.I.I.^1 ; Ayub, M.A.^1 ; Omar, R.^2

Structural Dynamics Analysis and Validation (SDAV), Faculty of Mechanical Engineering, Universiti Teknologi MARA (UiTM), Selangor, Shah Alam

40450, Malaysia^1

Machinery Technology Centre, SIRIM Industrial Research, Hulu Selangor, Selangor

44200, Malaysia^2

关键词: Dynamic behaviours;    Engineering structures;    Experimental modal analysis;    Frequency response functions;    Laser spot weld;    Model updating;    Synthesised;    Updating methods;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/506/1/012012/pdf
DOI  :  10.1088/1757-899X/506/1/012012

学科分类：工业工程学

来源: IOP

【 摘 要 】

Accurate analytical models of engineering structures are of paramount importance for dynamicists to be used in predicting the dynamic behaviour (frequency response function) of the structures. The finite element method (FEM) and the experimental modal analysis (EMA) have been known as powerful and useful methods that can be used to determine the frequency response function (FRF) of the structures. However, the finite element FRF are often not in good agreement with experimental FRF due to assumption properties in finite element (FE) model. Therefore, in order to have a reliable FE model of a structure, measured FRF obtained from the experimental modal analysis can be integrated with finite element FRF to reconcile the FE model and the procedures involved in the reconciliation is a model updating process. Prior performing the updating process, the experimental FRF must be in good quality to obtain accurate FE model results. One way to reduce noise data and eliminate suspicious modes in FRF data is to use the FRF synthesised method. The main goal of this study is to use frequency response function based updating to minimise the error of a laser spot welded structure by using FRF synthesised data. In this work, MSC Software and LMS Test Lab were used to predict and measured the FRF of laser spot welded structure. The results revealed that FRF based updating method is successfully reduced the correlation gap between synthesised FRF and predicted FRF.