Design, Develop and Simulate Microdrilling Cutting Tool

1st International Conference on Industrial and Manufacturing Engineering

工业技术（总论）;机械制造

Siregar, Ikhsan^1 ; Saedon, J.B.^2 ; Adenan, Mohd Shahriman^2 ; Azmi, Muhammad Firdaus Mohammed^3 ; Harun, Anis Fatihah Binti^2

Fakultas Teknik, Universitas Sumatera Utara, Kampus USU, Medan, Indonesia^1

Faculty of Mechanical Engineering, Universiti Teknologi MARA, Selangor Shah Alam, Malaysia^2

Politeknik Sultan Azlan Shah, Behrang Ulu, Negeri Perak, Malaysia^3

关键词: ABAQUS software;    Cutting forces;    Cutting temperature;    Independent variables;    Micro models;    Micro-drilling;    Model and simulation;    Von Mises;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/505/1/012094/pdf
DOI  :  10.1088/1757-899X/505/1/012094

学科分类：工业工程学

来源: IOP

【 摘 要 】

Microdrilling has an important role in the world of modern industry, especially in terms of miniaturizing existing products or components. Through this research explain the design, development of design and simulate microdrilling cutting tools. By using four geometries that are different from the previous model of micro drilling tools, a development, modeling and simulation were carried out and analyzed using Finite Element Analysis (FEA) using ABAQUS Software. Titanium alloys (Ti6Al4V) and tungsten carbide (WC) materials were chosen as one of the materials for the workpiece and cutting tools respectively. Microdrilling device is a constant variable, as for the amount of flutes and point angles is an independent variable. Cutting force, cutting temperature and Von Voltage misses from the micro model are analyzed from the simulation results based on these independent variables. After observing it turns out that fewer flutes will cause a high value to cut the temperature, cut the strength and also Von Mises.