Influence of cutting speed on coated TiCN cutting tool during turning of AISI 316L stainless steel in dry turning process

1st International Conference on Industrial and Manufacturing Engineering

工业技术（总论）;机械制造

Zaharudin, A.M.^1 ; Budin, S.^1

Faculty of Mechanical Engineering, Universiti Teknologi MARA Cawangan Pulau Pinang, Permatang Pauh, Pulau Pinang

13500, Malaysia^1

关键词: AISI316L stainless steel;    Coated titanium;    Cutting process;    Cutting speed;    Dry turning;    High hardness;    TiCN coatings;    Wear rates;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/505/1/012044/pdf
DOI  :  10.1088/1757-899X/505/1/012044

学科分类：工业工程学

来源: IOP

【 摘 要 】

Coated Titanium Carbon-Nitride (TiCN) cutting tools are widely used in the industry to improve the surface quality, tool life and wear resistance because of its high hardness, superior chemical properties and thermal stability. In this work, coated TiCN was used for turning of AISI 316L stainless steel. The rotating cutting speeds selected in the experiments were 185, 415 and 660 rpm. It is observed that the surface roughness of the workpiece decrease while the wear rate increases of the cutting tool with the increasing of rotational cutting speed. TiCN coating not only ensure the cutting tools is wear resistance, but also ensure that the surface quality is maintained during cutting process.