BER Reduction Using Precoded OFDM in Power-line Channel

11th Curtin University Technology, Science and Engineering (CUTSE) International Conference

工业技术（总论）

Herath, Sudeepa Madushanka^1 ; Reine, Regina^2 ; Zang, Zhuquan^2 ; Juwono, Filbert H.^2

Department of Engineer, INTEL Malaysia, Malaysia^1

Department of Electrical and Computing Department, Curtin University Malaysia, Malaysia^2

关键词: BER performance;    High bit error rates;    High data rate communications;    Noise mitigation;    Peak to average power ratio;    Power line channels;    Power line communications (PLC);    Reliable communication;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/495/1/012040/pdf
DOI  :  10.1088/1757-899X/495/1/012040

学科分类：工业工程学

来源: IOP

【 摘 要 】

Power-line Communications (PLC) effectively uses the pervasive power grid as a high data rate communication medium. Despite its advantages, the presence of severe multipath fading and susceptibility to impulsive noise make reliable communication in a PLC system challenging. In PLC systems, orthogonal frequency-division multiplexing (OFDM) is an attractive choice mainly due to its resilience to multipath fading. However, OFDM signals suffers from large peak-to-average power ratio (PAPR) thus resulting in non-linear signal distortions at the transmitter. Therefore, for an OFDM-based PLC system, the combined effect of large PAPR and the presence of impulsive noise results in high bit error rate (BER). This paper proposes the use of precoding at the transmitter to reduce PAPR, and blanking non-linearity at the receiver to mitigate impulsive noise. Precoding is a data-independent and robust PAPR reduction scheme that essentially distributes the power of the individual OFDM symbols over the entire OFDM block. Blanking is an effective impulsive noise mitigation technique that results in better BER performance at the receiver. Simulation results show that, with the combination of precoding and blanking, significant gains in BER performance for an OFDM based PLC system can be obtained with minimal increase of transceiver complexity.