Investigation of HVOF-ID spraying with WC-CoCr -15+5 μm feedstock powder

21st Chemnitz Seminar on Materials Engineering – 21. Werkstofftechnisches Kolloquium

Tillmann, W.^1 ; Schaak, C.^1 ; Hagen, L.^1 ; Dildrop, M.^1

TU Dortmund University, Institute of Materials Engineering, Germany^1

关键词: Chemical compositions;    Deposition efficiencies;    High Velocity OxygenFuel (HVOF) spraying;    Micro-structural characteristics;    Multicriteria optimization;    Particle-size fractions;    Statistical design of experiments;    Systematic analysis;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/480/1/012008/pdf
DOI  :  10.1088/1757-899X/480/1/012008

来源: IOP

【 摘 要 】

High velocity oxygen fuel (HVOF) spraying of WC-Co(Cr) with different chemical compositions, different powder size fractions, and different mean carbide sizes is a well-established research field for outer diameter (OD) applications. These coatings are typically applied as wear protective layers for different types of industries. Current demands for internal diameter (ID) coatings lead to a great interest in HVOF-ID spraying. This field of application necessitates a special spray gun equipment and spray powders with particle size fractions smaller than 20 μm. At the same time, the process control concerning both the spray gun configuration and the use of fine powders leads to new challenges which differ from those of OD HVOF spraying. In this study, HVOF-ID spraying using a WC-CoCr 86-10-4 (-155 μm) feedstock with a mean WC particle size of 400 nm is investigated with respect to the resulting coating properties. A statistical design of experiments (DoE) is utilized to enable a systematic analysis of various process parameter settings along with their interaction on the microstructural characteristics as well as the deposition efficiency (DE). Based on the results, a desirability-based multi-criteria optimization is carried out in order to produce adequate coating properties. The obtained knowledge about the spray system enables to realize dense WC-CoCr coatings with a porosity of approximately 1 %.