Pre-heating of multi-axial forging (MAF) on aluminum based composites

2nd Mineral Processing and Technology International Conference

工业技术（总论）;矿业工程

Pramono, A.^1 ; Yolanda, A.^1 ; Alhamidi, A.A.^1

Department of Metallurgy Engineering, Universitas Sultan Ageng Tirtayasa, Cilegon, Banten

42435, Indonesia^1

关键词: Aluminum scraps;    Base material;    Grain boundary shape;    Hardness values;    Microhardness tests;    Microstructure observation;    Weight fractions;   

Others  :  https://iopscience.iop.org/article/10.1088/1757-899X/478/1/012029/pdf
DOI  :  10.1088/1757-899X/478/1/012029

学科分类：工业工程学

来源: IOP

【 摘 要 】

Aluminum is one of the materials used for automotive, almost 90% of aluminum scrap from automotive cars can be recycled. The properties of aluminum are light and have a high ductility. The addition of SiC as reinforcement to aluminum based composite materials by multi-axial forging (MAF) is one of the newly developed SPD processes. Addition of SiC is to increase strength greater than the base material. The purpose of this research is to know the micro structure especially spread of distribution of precipitate evenly in matrix and change of mechanical properties after MAF process. Therefore, variation of weight fraction of SiC and pre-heating temperature were conducted. Kind of aluminum type AA1100 shaped plate as matrix added SiC as reinforcement, using variation 0.2%:0.4% and 0.6% wt. As for pre-heating temperature variation of 350°C, 450°C and 550°C then done MAF process with every change of pass rotate 90°. The results obtained from aluminum-based composite study by MAF, that with the addition of SiC on microstructure observation there is a change of grain boundary shape from equaxial to lamellar, there are grains of precipitate on the matrix that spread evenly and tensile test results and microhardness test increased along with the addition SiC fraction at a temperature of 350°C while for temperatures of 450°C and 550°C there is a decrease in hardness value, tensile strength value on Al/SiC.